Malossi Team II Inner Rotor Ignition for Aprilia / Piaggio / Vespa

Description Malossi Team II Inner Rotor Ignition for Aprilia / Piaggio / Vespa If you have removed or held a factory flywheel in your hands before, you’d know how heavy they are. Each time the throttle is applied, the crankshaft has to forcibly spin up the weight of this giant engine anchor which is hanging directly off its side. Inner rotor ignitions essentially work in the reverse, having a super light flywheel built into a the inside of the stator rather than rotating around the outside – keeping the heavy part of the system un-driven, and the driven part of the system as close to the centre of the crank as possible to reduce the effect of centrifugal force. This allows the engine to far more rapidly rev, as the flywheel is providing far less resistance to the engine changing rapidly in RPM. MHRTEAM2 TECHNICAL FEATURES CDI Control unit with variable ignition timing and 3 trimmers: MAPS trimmer: selects the ignition timing map OFFSET trimmer: shifts the selected map by ± 2° LIM trimmer: selects the rev limit (16 possible settings) 8 preset maps: 1 variable ignition timing map for 4-stroke engines 6 variable ignition advance maps for 2-stroke engines 1 fixed ignition timing map The system is based on a uP STM8 – 8-bit microprocessor with a processing speed of 20MIPS (Million Instructions Per Second). Reduced processing time, improved precision and stability of ignition timing. Hardware architecture with improved immunity to interference. 105°C temperature class cable. Compensation of the flywheel installation error of ± 2° with 0.5° steps via an external trimmer. 8 ignition advance tables, selectable via an external trimmer Vector ignition advance tables with 24 interpolation points and linear interpolation. Adjustable speed limitation via an external trimmer with 16 settings. The soft-cut function ensures that the speed limit is gradually switched off. 15 settings for adjusting the speed limit between 11,500 rpm and 14,300 rpm in steps of 200 rpm as well as a setting for deactivating the speed limiter. MHRTEAM2 High-voltage coil Maximum discharge voltage > 40 KV at motor speeds >3000 rpm Maximum peak open-circuit voltage gap > 50KV Ramp-up time at 10 bar > 1750 V/uS Rotor-stator unit The weight of the stator has been reduced by around 30 % – 100 g in total. Monolithic magnetic circuit with high permeability. Optimized magnetic path. Reinforcement of the wound part by cables with higher insulation class and larger wire diameter. Improved electrical performance by 20%. Reduction of the minimum starting speed from 450 rpm to 370 rpm. Miniaturized impermeable plug with IP67 protection, with retention fuse. Automotive class wiring. Rotor Ø 58 with neodymium permanent magnets. WARNING: With this type of ignition, the lighting system is not connected. Digi Controller, #5517976B